iEA Intelligent Engine Analyzer

iEA Intelligent Engine Analyzer

$3,100.00

iEA – a comprehensive pressure transducer kit with software for misfire detection.

SKU: EMI1030 Category:

Our iEA (Intelligent Engine Analyzer) brings your shop more must have Patented diagnostic equipment technology.

With iEA, view in-cylinder, intake manifold and exhaust system pressures all at the same time!

Perfectly pairs with our ELITE4 and ELITE8 eSCOPES to view multiple transducers at once!

Kit Contents

  • iEA Amplifier
  • iEA Spark Tester with RF Filter
  • iEA Exhaust Sensor
  • 14mm Compression Tester Adapter
  • 18mm Compression Tester Adapter
  • 12mm Compression Tester Adapter
  • Ford 5.4L 3 Valve Compression Tester Adapter
  • -30hg Vacuum Transducer
  • 300psi Transducer
  • 500psi Transducer
  • 3/8in Hose Adapter
  • 1/4in Hose Adapter
  • Pressure Transducer Cables
  • Phono Jack to Phono Jack Cable
  • Exhaust Tail Pipe Hose
  • Quick Connect Coupler
  • USB Software Card
  • Hard Plastic Travel Case with Foam Padding

Camshaft timing off by one tooth?

That’s a very difficult challenge that will take hours of your time to prove. What if we told you that you could tell if the camshaft timing is off by as little as one tooth, in as little as five minutes. You would think we were CRAZY…. Well we aren’t! Our iEA – Intelligent Engine Analyzer uses advanced technology to check the pressure changes in the cylinders THROUGH THE SPARK PLUG HOLE!

INCREDIBLE? We think so.

Got a random misfire code, miss-identified misfire code, or no code at all, and the vehicle is misfiring? Another very difficult challenge that will take hours of your time to figure out. Our iEA shows you which cylinder or cylinders are missing through the exhaust tailpipe and then checks the mechanical condition of the cylinder through the spark plug hole in just minutes! ATS’ revolutionary iEA software automatically identifies problems and alerts the technician; saving hours of diagnostic time.

View large, colorful, razor sharp waveforms on your hi-res PC display. No laptop? No problem. We’ll load the iEA onto a customized, shop-tough laptop, and ship you the works, ready to roll. Just fire it up and go.

â–º Quickly identifies camshaft timing problems through the spark plug hole.

â–º Quickly identifies misfiring cylinders from the exhaust tail pipe.

â–º Finds problem cylinders and identifies them quickly.

â–º Misfire counters provide information on which cylinders misfired and counts

 how many times the misfire occurred.

â–º Will alert you to a bank misfire, random misfire, or individual misfire.

â–º Checks cranking, intake and exhaust pressure pulsation confirming mechanical condition of engine quickly.

â–º Checks restricted exhaust system.

â–º Checks ignition timing.

â–º Chosen one of the TOP 20 TOOLS of 2008 by Motor Magazine and one of the TOP 10 TOOLS of 2008 by Undercar Digest!

â–º Converts pressure transducer voltage to actual pressure or vacuum readings

â–º Powers up and reads up to four Pressure Transducers at one time.

â–º Can be used in conjunction with all ATS diagnostic equipment.

â–º Free software updates!

â–º Free technical support!

System Requirements:

► Runs on most Intel or AMD Processor Windows based PC with type A USB 2.0 port.

Will NOT run on the Microsoft Surface Pro X ARM64-based PC with the Microsoft SQ1 processor.

â–º Windows 7 Service Pack 1 through Windows 11 operating systems including Windows 11 tablets

(Windows RT tablets are not supported)

The Most Complete Kit Available

Built-in and  easy to follow setup and  configurations.

iEA Easy Configuration
In-cylinder pressure testing

See exactly what’s happening inside each cylinder.

Accurately measure intake manifold pressure variations.

Intake pressure testing
Tailpipe pressure testing

Use Tailpipe Exhaust Pressure to Find a Misfiring Cylinder.

Confidently Capture, Display & Diagnose Pressure Waveforms

Pairs with ATS eSCOPES

Drives four pressure transducers at once with full pressure / vacuum conversions

Kit Contents

 

IEA Amplifier (Venturi) (EMI1010)

 

500psi Transducer (PTR1040)

 

300psi Transducer (PTR1030)

 

-30hg Vacuum Transducer (PTR1020)

 

Spark Tester with RF Filter (EMI1040)

 

IEA Exhaust Sensor (-20 H20) (PTR1060)

 

Exhaust Tail Pipe Hose (PTR1070)

3 x Pressure Transducer Cables (PTR1080)

Phono Jack to Phono Jack Cable (PTR1090)

 

Vacuum Test Hose (EMI2150)

 

14mm Compression Tester Adapter Stainless Steel (EMI2100)

 

18mm Compression Tester Adapter Stainless Steel (EMI2120)

 

12mm Compression Tester Adapter (EMI2130)

 

Ford 5.4L 3 Valve Stainless Steel Compression Tester Adapter (EMI2140)

 

1/4″ Hose Adapter (PTR1160)

 

3/8″ Hose Adapter (PTR1170)

 

Quick Connect Coupler-Small (PTR1185)