1999 Ranger 2.5L std. trans, 117K miles
by Rusty Flake – Beck Service Center
Complaint: Starts and idles fine, but surges when put into gear.
When I went and started the truck, it bucked and jerked and died several times before it got to where it would even idle. After letting it run long enough to stabilize at idle(several minutes) I tried to drive it into the shop, it could not be throttled up or it would sputter and jerk and die. I had to let it idle and slowly release the clutch to get it rolling enough to coax it into the shop.
After finally getting into my bay, I pulled codes and retrieved P0171 sys lean, I then connected my gas analyzer to look at lambda out the tail pipe. The exhaust showed between 25-30% lean when Idling fairly smoothly, I still could not bring it off idle, fast or slow, when trying too, the exhaust lambda reading went to 80% lean, when it didn’t die out completely before it could be kept running. The fuel system on this truck is return less, the fuel spec., when converted in all data was 63 psi.
I connected my flow meter with the outlet hose into ma container and restricted, to allow some type of a measure-ment of flow. The pressure showed 61 psi and flow was .2 gpm, when the restriction was opened to allow .5 gpm the pressure dropped to 50 psi. At this time I recommend a fuel pump and filter with a potential check of power and ground through the sender and suggest sending the injectors out for cleaning. The job was approved and completed, with a result that wasn’t good. Basically the truck ran the same with the exception that it took less time for it to be able to idle and could be snap throttled now without dying. Looking at fuel trims, O2’s and lambda, this truck was still running very lean. Since I can now snap throttle I look at MAF sensor waveform, not good, replaced MAF sensor and finally the truck is fixed.